DavidCadogan.ca Forums

DavidCadogan.ca Forums » DavidCadogan.ca

1. aggregatecrushing
   Member

   separator spindle installation: First, install separator spindle must meet the following three requirements Raymond Mill: ① spindle and parts mounted on the spindle of work have accurate position; parts ② spindle facilitates installation and disassemble, adjust; ③ spindle should have good manufacturing processes. Secondly, placed the order separator spindle parts as follows: flywheel, bearings, disc, bushings, bearings, pulleys, specifically as follows: The spindle has a splined shaft section 3, in order to reduce the required workpiece clamping Time should be opened on these different shaft section keyway on the same bus axis. In addition, to reduce the types of cutting tools and improve labor productivity, the shaft diameter approximate place, fillets, chamfers, keyway width, wheel overrun groove width, undercut width as far as possible the same size. Again, because the spindle is a stepped shaft, according to the characteristics of the ladder shaft and shaft parts of the installation requirements are not high, so the above-mentioned article easily met. The third article: the manufacturing process of the shaft, mainly refers to the easy axis machining and assembly of parts. And high productivity, low cost. Generally, the more simple structure, process better. So we should try to simplify the structure of the shaft. In order to facilitate assembly parts and remove the burr, the shaft should make a 45-degree chamfer Raymond Mill. In the shaft section requires cutting thread, it should be left undercut. Size can be checked from the relevant standards and manuals. If you need a grinding axis machining section should be left wheel and the drive slot. Henan Mining Machinery Co., Ltd. specializing in the production of various types of magnetic separator, beneficiation process design free, year-round supply of spare parts. If you have any needs, you can exercise power directly to us:

   Posted 10 years ago #

RSS feed for this topic

Reply

You must log in to post.