The larger difference between the milling process and the crushing process is in addition to the differences in the use of equipment, and also the difference in the expression of the particle size of the output. The state of the material presented by the crushing process is mostly granular, while the milling The processing result is powder, which is the greater difference in its principle and structure. For the milling process of barite ore, we use the following milling equipment: Raymond Mill, High Pressure Mill, High Strength Mill and Super Fine Mill reflect:
1.Raymond mill
RAYMOND MILL FOR is a kind of equipment that is welcomed by customers in the milling equipment, especially in terms of material handling, it can reflect its specific advantages. Modern Raymond mills are compared with traditional equipment. In the production efficiency has been greatly improved, and the internal structure is fully established in the case of high production efficiency carefully and reasonably designed. Its maturity can only be fully expressed through comparison. The larger reason for the low efficiency of the early milling equipment was that the internal structure of the equipment was too messy and more prone to clogging. Once the equipment was clogged, the operation was bound to be blocked. The production efficiency of the equipment has been seriously affected, and the new Raymond mill aims at the root cause of this problem, and the right solution is adopted. The internal structure is reasonably assembled using highly integrated modules, which not only avoids the danger of material blockage, but also Provides great convenience for equipment maintenance, maintenance and repair work.